Logo

U012B Engine Trouble Code

Meaning of U012B engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U012B Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U012B code is occuring now you should check U012B repair processes.
Now don't ask yourself; What should you do with U012B code ?
The solution is here :

U012B Possible Solution:

U012B Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

U012B Code Meaning :

U 0 1 2 b
OBD-II Diagnostic Network (U) Trouble Code For Engine Intake Valve Control Solenoid Circuit Low Fuel Rail/System Pressure - Too High Turbocharger Boost Sensor A Circuit Low

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U012B OBD-II Diagnostic Network (U) Trouble Code Description

U012B engine trouble code is about .

Main reason For U012B Code

The reason of U012B OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

U012B DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.